GAMETRAQ 6 court setup

Make sure you have everything on hand before heading to the court:

• GAMETRAQ 6 AI Camera
• Camera holder / mounting bracket
• Screws for camera holder
• CAT 6 network cable
• PoE-enabled router, switch, or injector
• Ladder or safe lifting equipment
• Plastic cable ties or metal screws
• Microphone with clip
• SLAMS button panel with cord
• QR poster (PDF from GAMECAM, printed by club)

1. Locate the internet router, PoE switch, or PoE injector.
2. Pull a CAT 6 cable from the router or PoE device to the court.
3. Make sure the cable reaches the camera position.
4. Secure the cable so it does not disturb players or create a trip hazard.
5. PoE means the same cable provides both power and internet to the camera.

1. Place the GAMETRAQ 6 camera on a stable surface.
2. Position the camera holder against the camera.
3. Attach the holder using the supplied screws.
4. Tighten the screws carefully.
5. Make sure the camera is firmly attached and cannot move.

The camera must be mounted on the center of the short side of the court, aligned with the center of the court.

1. Use a ladder or safe lifting equipment.
2. Place the camera and holder on the center of the short side.
3. Make sure the camera faces the court and is positioned straight.
4. Attach the holder to the court structure using cable ties or metal screws.
5. Check that the camera is stable and cannot move.

Correct camera placement is important for AI tracking and video quality.

1. Attach the microphone to the court fence using the clip.
2. Place it where it is protected and does not disturb players.
3. Secure any loose cable with cable ties if needed.

1. Connect the CAT 6 cable to the GAMETRAQ 6 unit.
2. Make sure the cable is fully inserted.
3. Wait for the camera to power on and connect to the internet.
4. Find the 3-digit camera code on the rear side of the camera.
5. Open install.gamecam.se/check.php.
6. Enter the 3-digit code and run the connection check.

When the camera shows ONLINE, send the Camera ID or 3-digit camera code to v@gamecam.se. You can also send the Camera ID in your GAMECAM support group.

1. Place the SLAMS button panel on the net post.
2. Use the cord to attach it securely.
3. Make sure it is easy for players to reach.
4. Check that it does not block the net or disturb the game.

1. Place the printed QR poster on the outside of the court.
2. Make sure it is clearly visible for players.
3. Make sure the QR code is easy to scan with a mobile phone.

• Camera is stable and facing the court
• CAT 6 cable is connected to the GAMETRAQ 6
• PoE device is connected and powered
• Camera shows ONLINE
• Microphone is attached to the fence
• SLAMS button panel is attached to the net post
• QR poster is visible for players
• GAMECAM has received the Camera ID